Has your Aire pegboard just arrived? Here is the official step-by-step assembly manual. To choose the drilling and anchors according to your wall type (drywall, concrete, brick), consult the complete fixing guide.
1. Prepare the screws
🔧 Slightly screw the 4 (or more) screws into the special holes of the Pegboard with the provided Torx10 key. Leave 5 mm protruding.
2. Position the Pegboard
🧱 Place it on the wall where desired.
📐 Use a level to align it horizontally or vertically.
3. Mark the wall
🔨 Hold the Pegboard in place and lightly tap the screw heads to mark the drilling points.
4. Drill the holes
🛠️ Remove the Pegboard.
Drill the marks with a 6 mm drill bit.
5. Insert the anchors
👊 Hammer the provided Fischer Duopower anchors into the holes.
6. Position the spacers around the screws
🧲 Place the calibrated spacers (without adhesive) around the Pegboard screws. These parts ensure the correct distance between the wall and the panel.
7. Stick the adhesive spacers
🧲 Stick the adhesive spacers to the back of the pegboard, evenly distributed across the surface, and without blocking the holes. These parts ensure the correct distance between the wall and the panel.
8. Attach the Pegboard
🔩 Align the Pegboard with the anchors and screw until the corners are flush against the wall. Use the provided wrench to finish tightening.
💡 No need to tighten too much: the hold is secure.
Congratulations! Your pegboard is installed and ready to use!
0 comments