How to fix your Aire Pegboard?
1. Prepare the screws
🔧 Lightly screw the 4 screws (or more) into the special holes of the Pegboard with the provided Torx10 key. Leave 5 mm protruding.
2. Position the Pegboard
🧱 Place it on the wall in the desired location.
📐 Use a level to align it horizontally or vertically.
3. Mark the wall
🔨 Hold the Pegboard in place and lightly tap the screw heads to mark the drilling points.
4. Drill the holes
🛠️ Remove the Pegboard.
Drill the marks with a 6 mm drill bit.
5. Insert the dowels
👊 Hammer the nylon anchors into the holes.
6. Position the washers around the screws
🧲 Place the adhesive-free washers around the pegboard screws. These pieces ensure the correct distance between the wall and the board.
7. Glue the adhesive spacers
🧲 Stick the adhesive washers to the back of the pegboard, evenly distributed over the entire surface, without obstructing the holes. These pieces ensure the correct distance between the wall and the panel.
8. Attach the Pegboard
🔩 Align the pegboard with the anchors and screw in until the corners are flush against the wall. Use the provided wrench to finish tightening.
💡 No need to overtighten: the fit is guaranteed.
Congratulations! Your pegboard is installed and ready to use!
0 comments